Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during kick door control sensor removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Disconnect cable from negative (-) battery terminal | Memorize steering angle neutral point | Lane Control System | Refer to INITIALIZATION [08/2019 - ] |
| Pre-collision System | |||
| Intelligent Clearance Sonar System *1 | |||
| Parking Assist Monitor System | Refer to INITIALIZATION [08/2019 - ] | ||
| Panoramic View Monitor System | Refer to INITIALIZATION [08/2019 - ] | ||
| Lighting System (w/ Automatic Headlight Beam Level Control System) | Refer to INITIALIZATION [08/2019 - 07/2020] , or refer to INITIALIZATION [07/2020 - ] | ||
| Initialize back door lock | Power Door Lock Control System | Refer to INITIALIZATION [09/2015 - ] | |
| Reset back door close position | Power Back Door System (w/ Outside Door Control Switch) | Refer to INITIALIZATION [08/2019 - ] |
*1: When performing learning using the Techstream.