Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel lid opener motor assembly removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Disconnect cable from negative battery terminal | Memorize steering angle neutral point | LKA /LDA system | Refer to INITIALIZATION [09/2015 - 08/2019] |
| Pre-collision system | |||
| Intelligent clearance sonar system *1 | |||
| Lighting system (w/ Automatic Headlight Beam Level Control System) | Refer to INITIALIZATION [09/2015 - 08/2019] | ||
| AFS (Adaptive Front-lighting System) | Refer to INITIALIZATION [09/2015 - 08/2019] | ||
| Parking assist monitor system | Refer to INITIALIZATION [09/2015 - 08/2019] | ||
| Panoramic view monitor system | Refer to INITIALIZATION [09/2015 - 08/2019] | ||
| Initialize back door lock | Power door lock control system | Refer to INITIALIZATION [09/2015 - ] | |
| Reset back door close position | Power back door system | Refer to INITIALIZATION [09/2015 - 08/2019] |
*1: When performing learning using the Techstream.
Refer to CALIBRATION [08/2016 - 12/2017]
WARNING:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Refer to PRECAUTION [08/2016 - 12/2017]