Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during back door closer ECU removal/installation are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Multiplex network door ECU | Reset Back Door Close Position | Power back door system | Refer to INITIALIZATION [09/2015 - 08/2019] |
NOTE:
When replacing the multiplex network door ECU, the back door automatic open stop position (memory stopped position) must be registered, so be sure to make a note of the automatic open stop position.