Freeze Frame Data [08/2019 - ]
- FREEZE FRAME DATA
- Whenever a meter DTC is detected, the combination meter assembly stores the current vehicle state as freeze frame data.
- CHECK FREEZE FRAME DATA
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Combination Meter / Trouble Codes.
- According to the Techstream display, select a DTC that stored freeze frame data.
- Read the freeze frame data recorded when the DTC was stored.COMBINATION METER
Tester Display Condition Displayed Item B1321 Lost Communication with EMV - Trip
- Elapsed time after turning the engine switch on (IG)
B1326 Lost Communication with Clock Device (Local-CAN) B1507 Open in Turn Signal Circuit B1508 Short in Turn Signal / Hazard Flasher Circuit U0100 Lost Communication with ECM / PCM "A" U0129 Lost Communication with Brake System Control Module U0131 Lost Communication with Power Steering Control Module U0140 Lost Communication with Body Control Module U0151 Lost Communication with Restraints Control Module U0163 Lost Communication with Navigation Control Module U0182* Lost Communication with Lighting Control Module Front U023A Lost Communication with Front Camera Module - *: w/ Automatic Headlight Beam Level Control System
- CLEAR FREEZE FRAME DATA NOTE:
Clearing the DTCs will also clear the freeze frame data.
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Clear DTCs and freeze frame data.
Refer to DTC CHECK / CLEAR [09/2015 - ]
Body Electrical > Combination Meter > Clear DTCs