Removal [09/2015 - 08/2016]: Procedure

Refer to PROCEDURE - Step 1

See step  3

1. Disconnect the 3 connectors.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Remove the bolt, 4 nuts and rear skid control sensor wire LH.

1. Disconnect the 3 connectors and disengage the 3 clamps.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Remove the bolt, 4 nuts and rear skid control sensor wire RH.

1. Using a jack and wooden block, support the rear No. 2 suspension arm assembly.
   NOTE:

   • When jacking up the rear No. 2 suspension arm assembly, be sure to jack it up slowly.
   • Make sure to perform this operation with the vehicle kept as low as possible.
   • Keep supporting the rear No. 2 suspension arm assembly with a jack until the installation of the rear shock absorber assembly has been completed.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Wooden Block
   *b	Jack
   	Wooden Block Placement Location

2. Remove the 2 bolts, nut and the rear shock absorber assembly from the vehicle.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Using a jack and wooden block, support the rear No. 2 suspension arm assembly.
   NOTE:

   • When jacking up the rear No. 2 suspension arm assembly, be sure to jack it up slowly.
   • Make sure to perform this operation with the vehicle kept as low as possible.
   • Keep supporting the rear No. 2 suspension arm assembly with a jack until the installation of the rear shock absorber assembly has been completed.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Wooden Block
   *b	Jack
   	Wooden Block Placement Location

2. Remove the 2 bolts, nut and the rear shock absorber assembly from the vehicle.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002