Removal [09/2015 - 08/2016]: Procedure

PRECAUTION
NOTE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Refer to PRECAUTION [09/2015 - 12/2017]
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [09/2015 - 08/2016]
REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL
Refer to PROCEDURE - Step 2
REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
Refer to PROCEDURE - Step 3
REMOVE INSTRUMENT CLUSTER FINISH PANEL ORNAMENT
Refer to PROCEDURE - Step 5
REMOVE LOWER INSTRUMENT FINISH PANEL SUB
Refer to PROCEDURE - Step 10

REMOVE RADIO RECEIVER ASSEMBLY WITH REGISTER

Remove the 2 bolts.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Pull the radio receiver assembly with register toward the rear of the vehicle to disengage the 7 clips.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove in this Direction

REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

Using a screwdriver, disengage the 4 claws and remove the No. 3 instrument panel register assembly as shown in the illustration.

HINT:

Tape the screwdriver tip before use.

REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY
HINT:

Use the same procedure as for the No. 3 instrument panel register assembly.
REMOVE RADIO RECEIVER ASSEMBLY