Turn Signal Switch Circuit [10/2014 - 09/2017]: Procedure

1. Using the Techstream, read the Data List.

   Refer to DATA LIST / ACTIVE TEST [10/2014 - 09/2017]

   Body Electrical > Combination Meter > Data List 

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   Turn Signal Switch (Right)	Turn signal switch (right) signal	ON or OFF	ON: Turn signal switch (right) on OFF: Turn signal switch (right) off	-
   Turn Signal Switch (Left)	Turn signal switch (left) signal	ON or OFF	ON: Turn signal switch (left) on OFF: Turn signal switch (left) off	-

   Body Electrical > Combination Meter > Data List 

   Tester Display
   Turn Signal Switch (Right)
   Turn Signal Switch (Left)

   Result

   Result	Proceed to
   Data list values are as specified	A
   Data list values are not as specified	B

Result: 

A 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [10/2014 - 09/2017] 

Result: 

B 

See step  2

1. Remove the headlight dimmer switch assembly.

   Refer to REMOVAL [10/2014 - 05/2019]

2. Inspect the headlight dimmer switch assembly.

   Refer to INSPECTION [10/2014 - 07/2020]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE HEADLIGHT DIMMER SWITCH ASSEMBLY. Refer to  REMOVAL [10/2014 - 05/2019] 

Result: 

OK 

See step  3

1. Disconnect the I126 headlight dimmer switch assembly connector.
2. Disconnect the I11 combination meter assembly connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   I126-11 (TL) - I11-4 (EL)	Always	Below 1 Ω
   I126-12 (TR) - I11-3 (ER)
   I126-13 (CR) - I11-8 (SW)
   I126-15 (EL) - Body ground
   I126-11 (TL) - Body ground	Always	10 kΩ or higher
   I126-12 (TR) - Body ground
   I26-13 (CR) - Body ground

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [10/2014 - 09/2017] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR