LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> NX 300 Base, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Exterior Lights >> Lighting System (Triple Beam Headlight) - Diagnostic Codes & Symptom Tests >> LIGHTING SYSTEM (For Triple Beam Headlight) >> DTC B2443: Lost Communication with Left Headlight and Right Headlight LIN [10/2014 - 09/2017] >> Procedure

DTC B2443: Lost Communication with Left Headlight and Right Headlight LIN [10/2014 - 09/2017]: Procedure

  1. CLEAR DTC 
    1. Clear the DTCs.

      Refer to DTC CHECK / CLEAR [10/2014 - 09/2017]

      Body Electrical > HL AutoLeveling > Clear DTCs 

      Result

      Proceed to
      NEXT

    Result: 

    NEXT 

    See step  2

  2. CHECK FOR DTC 
    1. Turn the engine switch on (IG).
    2. Inspect the light using the dimmer switch.
    3. Check for DTCs.

      Refer to DTC CHECK / CLEAR [10/2014 - 09/2017]

      Body Electrical > HL AutoLeveling > Trouble Codes 

      Result

      Proceed to
      DTC B2443 output does not occur
      DTC B2443 output occurs

    Result: 

    DTC B2443 output does not occur 

    USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - 09/2017] 

    Result: 

    DTC B2443 output occurs 

    See step  3

  3. CHECK HARNESS AND CONNECTOR (HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY LH - HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY RH) 
    1. Disconnect the A19 headlight light control ECU sub-assembly LH connector.
    2. Disconnect the A20 headlight light control ECU sub-assembly RH connector.
    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      A19-20 (LINL) - A20-20 (LINL) Always Below 1 Ω
      A19-20 (LINL) or A20-20 (LINL) - Body ground Always 10 kΩ or higher

      Result

      Proceed to
      OK
      NG

    Result: 

    NG 

    REPAIR OR REPLACE HARNESS OR CONNECTOR 

    Result: 

    OK 

    See step  4

  4. REPLACE HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY RH 
    1. Remove the headlight light control ECU sub-assembly RH.

      Refer to REMOVAL [10/2014 - 09/2017]

      Result

      Proceed to
      NEXT

    Result: 

    NEXT 

    See step  5

  5. CLEAR DTC 
    1. Clear the DTCs.

      Refer to DTC CHECK / CLEAR [10/2014 - 09/2017]

      Body Electrical > HL AutoLeveling > Clear DTCs 

      Result

      Proceed to
      NEXT

    Result: 

    NEXT 

    See step  6

  6. CHECK FOR DTC 
    1. Turn the engine switch on (IG).
    2. Check for DTCs.

      Refer to DTC CHECK / CLEAR [10/2014 - 09/2017]

      Body Electrical > HL AutoLeveling > Trouble Codes 

      Result

      Proceed to
      DTC B2443 output does not occur
      DTC B2443 output occurs

    Result: 

    DTC B2443 output does not occur 

    END (HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY RH WAS DEFECTIVE) 

    Result: 

    DTC B2443 output occurs 

    REPLACE HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY LH. Refer to  REMOVAL [10/2014 - 09/2017]