Installation [10/2020 - ]: Procedure

1. Insert the rear suspension toe adjust cam sub-assembly from the front of the vehicle. Then temporarily tighten the rear No. 2 suspension toe adjust plate and toe control link sub-assembly LH with the nut.
   NOTE:

   Align the matchmarks on the rear suspension toe adjust cam sub-assembly, rear No. 2 suspension toe adjust plate and rear suspension member sub-assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a

   Matchmark

2. Temporarily tighten the toe control link sub-assembly LH with a new nut.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Install the skid control sensor wire LH to the toe control link sub-assembly LH with the bolt.

   Torque: 8.5 N.m (87 kgf/cm, 75 in.lbf) 

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

See step  4

1. Fully tighten the nut (rear suspension member sub-assembly side).

   Torque: 78 N.m (795 kgf/cm, 58 ft.lbf) 

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a

   Matchmark

   NOTE:

   Align the matchmarks on the rear suspension toe adjust cam sub-assembly, rear No. 2 suspension toe adjust plate and rear suspension member sub-assembly.

2. Fully tighten the nut (rear axle carrier sub-assembly LH side).

   Torque: 118 N.m (1203 kgf/cm, 87 ft.lbf) 

Refer to PROCEDURE - Step 7

Refer to INSTALLATION [10/2017 - 10/2023] , or refer to INSTALLATION [10/2023 - ]

Refer to ADJUSTMENT [10/2020 - 10/2022] , or refer to ADJUSTMENT [10/2022 - 10/2023] , or refer to ADJUSTMENT [10/2023 - ]

Refer to ADJUSTMENT [10/2020 - 10/2023] , or refer to ADJUSTMENT [10/2023 - ]

Refer to WORK PROCEDURE [10/2020 - 11/2021] , or refer to WORK PROCEDURE [11/2021 - 10/2022] , or refer to WORK PROCEDURE [10/2022 - 10/2023] , or refer to WORK PROCEDURE [10/2023 - ]

Refer to ADJUSTMENT [10/2020 - ]