Installation [10/2017 - ]: Procedure

1. Install the 2 rear stabilizer bushings to the outside of the stoppers on the rear stabilizer bar.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Cutout
   *b	Stopper
   	Front of the Vehicle

   NOTE:

   Be sure to install the rear stabilizer bushings so that each cutout faces the front of the vehicle.

1. Install the rear No. 1 stabilizer bar bracket LH to the rear stabilizer bushing.
   NOTE:

   Be sure to install the rear No. 1 stabilizer bar bracket LH so that each arrow mark faces the front of the vehicle.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Arrow Mark
   	Front of the Vehicle

HINT: 

Perform the same procedure as for the LH side.

1. Install the rear stabilizer bar with the 4 bolts.

   Torque: 51 N.m (520 kgf/cm, 38 ft.lbf) 

   NOTE:

   Temporarily tighten the bolt (A), and then fully tighten the 4 bolts in the order of (B), (C), (D), and (A).

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

See step  4 [10/2017 - 10/2020], or see step  4 [10/2020 - 10/2023], or see step  4 [10/2023 - ]

HINT: 

Perform the same procedure as for the LH side.

Refer to INSTALLATION [10/2017 - 09/2019] , or refer to INSTALLATION [09/2019 - 10/2020] , or refer to INSTALLATION [10/2020 - 10/2023] , or refer to INSTALLATION [10/2023 - ]