Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear pneumatic cylinder removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced
| Replacement Part or Procedure | Necessary Procedures | Effects/Inoperative when not Performed | Link |
|---|---|---|---|
| Suspension, tires, etc. |
|
Panoramic view monitor system | w/ Advanced Park: Refer to CALIBRATION [11/2021 - 10/2022] w/o Advanced Park: Refer to CALIBRATION [11/2021 - 10/2022] |
NOTE:
- Be sure to read the "PRECAUTION" thoroughly before servicing.
Refer to PRECAUTION [10/2017 - ]
- In order to prevent the battery from becoming fully depleted, connect the battery charger to the auxiliary battery when turning the power switch on (IG) to charge the battery.
- Keep the power supply connected to prevent the Techstream battery from becoming fully depleted.
HINT:
- Use the same procedure for the RH and LH side.
- The following procedure is for the LH side.