Removal [10/2022 - 10/2023]: Procedure

PRECAUTION
- w/ Advanced Park:
  Refer to PRECAUTION [11/2021 - 10/2023]
- w/o Advanced Park:
  Refer to PRECAUTION [10/2020 - 10/2023]
PERFORM RESOLVER INITIALIZATION
Refer to UTILITY [10/2017 - ]
ADJUST STANDARD VEHICLE HEIGHT (w/ Air Suspension)
Refer to PROCEDURE - Step 2
REMOVE ENGINE ASSEMBLY WITH HYBRID VEHICLE TRANSMISSION
Refer to REMOVAL [10/2022 - 10/2023]

REMOVE MOTOR CABLE

WARNING:

Wear insulated gloves.

NOTE:

Cover the hole where the motor cable was connected with tape or equivalent (non-residue type) to prevent entry of foreign matter.
Insulate the removed terminals with insulating tape.
When removing the motor cable, make sure not to bend the motor cable base on the hybrid vehicle transmission assembly side.

Disconnect the 2 clamps of the motor cable from the engine assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Using an insulated tool, remove the 2 bolts and connector cover from the hybrid vehicle transmission assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Using a screwdriver, detach the 2 claws to remove the terminal cap from the hybrid vehicle transmission assembly.

Using an insulated tool, remove the 3 bolts from the motor cable terminals.

Using an insulated tool, remove the 2 bolts and motor cable from the hybrid vehicle transmission assembly.