Removal [10/2023 - ]: Procedure

PRECAUTION

WARNING:

Be sure to read precaution thoroughly before servicing.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NOTE:

After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.

DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

WARNING:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.

REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY
Refer to PROCEDURE - Step 9
REMOVE INSTRUMENT SIDE PANEL LH
Refer to PROCEDURE - Step 7
REMOVE LOWER NO. 1 INSTRUMENT PANEL PAD SUB-ASSEMBLY
Refer to PROCEDURE - Step 14
REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
Refer to PROCEDURE - Step 22
REMOVE GLOVE COMPARTMENT DOOR PAD PLATE
Refer to PROCEDURE - Step 31
REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY
Refer to PROCEDURE - Step 32

REMOVE HYBRID VEHICLE CONTROL ECU ASSEMBLY

Disconnect the 3 connectors.

Remove the bolt, nut and hybrid vehicle control ECU assembly.
NOTE:
- Do not drop the hybrid vehicle control ECU assembly, strike it with tools or subject it to impact.
- If the hybrid vehicle control ECU assembly is subjected to an impact, replace it with a new one.