LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> LS 500h AWD >> Repair and Diagnosis >> Engine Mechanical >> Lubrication System >> Engine Lubrication System - Service Information >> Oil Pressure Switch >> Installation [10/2023 - ] >> Procedure

Installation [10/2023 - ]: Procedure

  1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY 
    1. Remove any oil from the threads of the engine oil pressure switch assembly.
    2. Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.

      Adhesive

      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

      NOTE:

      Do not apply adhesive to the oil inlet port of the engine oil pressure switch assembly.

    3. Using a 24 mm deep socket wrench, install the engine oil pressure switch assembly.

      Torque: 15 N.m (153 kgf/cm, 11 ft.lbf) 

      NOTE:

      Do not start the engine for at least 1 hour after installation.

    4. Connect the engine oil pressure switch connector.
  2. ADD ENGINE OIL 

    Refer to PROCEDURE - Step 8

  3. INSPECT FOR OIL LEAK 

    Refer to PROCEDURE - Step 10

  4. INSPECT ENGINE OIL LEVEL 

    Refer to PROCEDURE - Step 2

  5. INSTALL NO. 1 AIR CLEANER INLET 

    Refer to PROCEDURE - Step 5

  6. INSTALL UPPER RADIATOR SUPPORT SEAL 

    Refer to PROCEDURE - Step 32

  7. INSTALL RADIATOR COVER PLATE 

    Refer to PROCEDURE - Step 33

  8. INSTALL LOWER RADIATOR AIR DEFLECTOR 

    Refer to PROCEDURE - Step 31

scientia non olet · About LEMON Manuals