Installation [10/2017 - 10/2020]: Procedure

1. Install the EGR cooler assembly to the cylinder head sub-assembly RH with the bolt and nut.

   Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

1. Connect the No. 12 water by-pass hose to the EGR cooler assembly, and slide the clamp to secure the hose.

1. Install the No. 3 water by-pass pipe to the EGR cooler assembly, and slide the clamp to secure the hose.
2. Install the engine motor cable clamp bracket with the bolt.

   Torque: 8.0 N.m (82 kgf/cm, 71 in.lbf) 

1. Connect the No. 4 water by-pass hose from the No. 3 water by-pass pipe, and slide the clamp to secure the hose.

1. Install 2 new gaskets to the No. 1 EGR pipe and EGR cooler assembly.
2. Install the No. 1 EGR pipe to the exhaust manifold assembly RH and EGR cooler assembly with the 2 bolts and 2 nuts.

   Torque: 21 N.m (214 kgf/cm, 15 ft.lbf) 

1. Install the outlet heater water hose to the No. 2 water by-pass pipe and heater pipe, and slide the 2 clamps to secure the hoses.

1. Install the inlet heater water hose to the No. 3 water by-pass pipe and heater pipe, and slide the 2 clamps to secure the hoses.

1. Install the fender apron brace sub-assembly RH to the body with the 2 bolts.

   Torque: 49 N.m (500 kgf/cm, 36 ft.lbf) 

2. Attach the clamp and connect the hose to the fender apron brace sub-assembly RH.

1. Temporarily install the inverter motor cable bracket assembly to the inverter assembly with the 2 bolts.
2. Tighten the 2 bolts.

   Torque: 8.0 N.m (82 kgf/cm, 71 in.lbf) 

3. Attach the 3 clamps and connect the generator cable and motor cable to the inverter motor cable bracket assembly.

Refer to INSTALLATION [10/2017 - ] 

Refer to PROCEDURE - Step 11

Refer to PROCEDURE - Step 12

Refer to PROCEDURE - Step 13

Refer to PROCEDURE - Step 14

Refer to PROCEDURE - Step 15

Refer to PROCEDURE - Step 17

Refer to INSTALLATION [10/2017 - 10/2020]