LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> LS 500h AWD >> Repair and Diagnosis >> Drivelines & Axles >> Wheel Hubs >> Axle And Differential - Service Information (1 Of 3) >> Front Axle Hub >> Removal [10/2023 - ] >> Procedure

Removal [10/2023 - ]: Procedure

  1. AIR SUSPENSION CONTROL PROHIBITED 

    Refer to PRECAUTION [10/2017 - ]

  2. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY 

    Refer to PROCEDURE - Step 18

  3. REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY 

    Refer to PROCEDURE - Step 20

  4. REMOVE STRUT BAR BRACKET SUPPORT SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 22

  5. DISABLE BRAKE CONTROL 

    Refer to PROCEDURE - Step 1

  6. REMOVE FRONT WHEEL 

    Refer to REMOVAL [10/2023 - ]

  7. DISCONNECT FRONT SPEED SENSOR WIRE 
    1. Remove the nut and sensor clamp.
      GTY806927Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. for LH Side:
      GTY806931Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Remove the bolt and speed sensor.
      2. Remove the bolt and sensor clamp.
  8. DISCONNECT DISC BRAKE CYLINDER ASSEMBLY 
    1. for RH side:

      except 6-Pot Caliper:

      1. Disconnect the pad wear indicator assembly.
        GTY827609Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      2. Detach the guide to remove the pad wear indicator assembly.
        GTY798695Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. for RH side:

      for 6-pot Caliper:

      Disconnect the bolt and front flexible hose from front flexible hose bracket LH.

      1. Disconnect the pad wear indicator assembly.
        GTY827609Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      2. Detach the guide to remove the pad wear indicator assembly.
        GTY776624Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. GTY806096Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Remove the 2 bolts and front flexible hose.

    4. Remove the bolt and bracket.
      GTY776625Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. GTY776621Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Loosen the bolts on the lower side of the disc brake cylinder assembly LH and remove the bolts on the top side.

      NOTE:

      Do not excessively loosen the bolts on the lower side of the disc brake cylinder assembly LH.

    6. Tilt the disc brake cylinder assembly LH and install SST as shown in the illustration.
      GTY778552Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      • SST: 09727-00110 
    7. Install SST to the No. 2 front suspension upper arm assembly LH.
      NOTE:

      The No. 2 front suspension upper arm assembly LH may become damaged if the metal part of SST contacts it. Therefore, install it so that the metal part does not contact the No. 2 front suspension upper arm assembly LH.

    8. Remove the bolt on the lower side of the disc brake cylinder assembly LH and disconnect it.
      GTY776620Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:
      • Do not apply excessive force to the flexible hose.
      • If there is no looseness in the flexible hose, adjust the length of SST.
  9. REMOVE FRONT DISC LH 
  10. REMOVE FRONT AXLE SHAFT NUT LH 
    1. Using a chisel and a hammer, release the staked part of the front axle shaft nut.
      GTY827615Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      Release the staked part of the nut completely, otherwise the threads of the drive shaft may be damaged.

    2. Using a 30 mm socket wrench, remove the axle hub nut.
  11. REMOVE FRONT DISC BRAKE DUST COVER LH 
    1. GTY776654Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Remove the 3 bolts and front disc brake dust cover LH.

  12. DISCONNECT TIE ROD ASSEMBLY LH 

    Refer to PROCEDURE - Step 16

  13. LOOSEN FRONT SUSPENSION LOWER ARM ASSEMBLY LH 

    See step  13

  14. DISCONNECT FRONT SUSPENSION UPPER ARM 

    Refer to PROCEDURE - Step 3

  15. REMOVE STEERING KNUCKLE LH 

    See step  15

  16. REMOVE FRONT AXLE HUB SUB-ASSEMBLY LH 
    1. Using a hexagon socket wrench 12 mm, remove the 4 bolts and front axle hub sub-assembly LH.
      GTY815145Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  17. REMOVE DISC BRAKE AIR GUIDE PLATE 
    1. Remove the disc brake air guide plate from the steering knuckle LH.
scientia non olet · About LEMON Manuals