Removal [10/2017 - ]: Procedure

REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY

Using moulding remover A, pull in the direction of the arrow (1) shown in the illustration to detach the claw.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

	Remove in this Direction (1)
	Remove in this Direction (2)

Pull in the direction of the arrow (2) shown in the illustration and remove the multiplex network master switch assembly from the front door trim board sub-assembly LH.
NOTE:
Do not damage the armrest.
Disconnect the connector.

Using moulding remover A, detach the claw and remove the multiplex network master switch assembly from the front door armrest upper base panel.