Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear bumper assembly removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED / INSTALLED / REPLACED
| Replaced Part or Performed Procedures | Necessary Procedures | Effect/Inoperative Function when Necessary Procedures are not Performed | Link |
|---|---|---|---|
w/ Hands Free Power Trunk Lid
|
Memorize steering angle neutral point | Lane-keeping assist system (for Mono camera type) | for Stereo Camera type: Refer to INITIALIZATION [10/2017 - 10/2020] for Mono Camera type: Refer to INITIALIZATION [10/2017 - 09/2018] |
| Lane control system (for Stereo camera type) | |||
| Parking support brake system* | |||
| Pre-collision system (for Mono camera type) | |||
| Pre-collision system (for Stereo camera type) | |||
| AFS (Front-lighting adaptive system) | |||
Lighting system (EXT)
|
|||
| Variable gear ratio steering system | Refer to INITIALIZATION [10/2017 - 10/2020] | ||
| Parking assist monitor system | Refer to INITIALIZATION [10/2017 - 10/2020] | ||
| Panoramic view monitor system | Refer to INITIALIZATION [10/2017 - 10/2022] | ||
| Initialize Rear Door Sunshade System | Rear door sunshade system | Refer to INITIALIZATION [10/2017 - ] | |
| Initialize power trunk lid system | Power trunk lid system | Refer to INITIALIZATION [10/2017 - 10/2020] | |
w/ Hands Free Power Trunk Lid
|
Reset connection history | There are cases where the connection history display differs from the vehicle condition | Refer to DATA LIST / ACTIVE TEST [10/2017 - 10/2023] |
| When the luggage compartment door is opened using a mechanical key | Initialize luggage closer motor assembly | The power trunk lid does not operate | Refer to INITIALIZATION [10/2017 - 10/2020] |
*: When performing learning using the Techstream.
HINT:
- If the bumper is damaged, there is a possibility that the installation area of the blind spot monitor sensor may be deformed and the blind spot monitor system may not operate correctly, so visually inspect the blind spot monitor sensor installation area (frame, stud bolt) to make sure it is not dented or bent.
Refer to ADJUSTMENT [10/2017 - 10/2020]
- If the visual inspection finds a problem, check the installation condition of the blind spot monitor sensor, and adjust the installation position of the blind spot monitor sensor as necessary.
- When the rear bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform ultrasonic sensor detection angle measurement.
Refer to CALIBRATION [10/2017 - 10/2020]