LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> LS 500h AWD >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Theft Deterrent System - Service Information >> Engine Hood Courtesy Switch >> Installation [10/2020 - 11/2021] >> Procedure

Installation [10/2020 - 11/2021]: Procedure

  1. INSTALL ENGINE HOOD COURTESY SWITCH (HOOD LOCK ASSEMBLY) 
    1. Apply MP grease to the sliding parts of the hood lock assembly.
    2. Connect the hood lock control cable assembly and hood lock control assembly to the engine hood courtesy switch (hood lock assembly).
      GTY800155Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Install the engine hood courtesy switch (hood lock assembly) with the 3 bolts.
      GTY837365Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Bolt
      Connector

      Torque: 8.0 N.m (82 kgf/cm, 71 in.lbf) 

    4. Connect the connector.
  2. INSTALL HOOD LOCK RELEASE LEVER PROTECTOR 
    1. Attach the clamp and temporary install the hood lock release lever protector.
      GTY801921Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the 2 clips.
  3. INSTALL FRONT BUMPER ASSEMBLY 

    Refer to INSTALLATION [10/2020 - 11/2021]

  4. INSPECT FITTING OF HOOD SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 1

  5. ADJUST HOOD SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 2

  6. ADJUST FRONT TELEVISION CAMERA ASSEMBLY (w/ Panoramic View Monitor System) 

    Refer to CALIBRATION [10/2017 - 11/2021]

  7. ADJUST FRONT LiDAR ADVANCED DRIVE SENSOR ASSEMBLY (w/ Advanced Drive) 
scientia non olet · About LEMON Manuals