Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are installed, removed or replaced during the headlight ECU sub-assembly LH removal/installation are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedures | Necessary Procedures | Effect/Inoperative Function when Necessary Procedures are not Performed | Link |
|---|---|---|---|
| Headlight ECU sub-assembly LH | Synchronize the vehicle information | Automatic headlight beam level control system | w/ Front LiDAR Sensor: Refer to REGISTRATION [10/2023 - ] w/o Front LiDAR Sensor: Refer to REGISTRATION [10/2023 - ] |
| Headlight ECU sub-assembly LH |
|
||
| Front bumper assembly (Including removal and installation) | Front television camera view adjustment | Panoramic view monitor system | Refer to CALIBRATION [10/2023 - ] |
w/ Front LiDAR Sensor:
|
|
Refer to ADJUSTMENT [11/2021 - ] |
HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.