Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are installed, removed or replaced during the headlight ECU sub-assembly LH removal/installation are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replacement Part or Procedure | Necessary Procedures | Effects/Inoperative Functions when not Performed | Link |
|---|---|---|---|
| Replacement of headlight ECU sub-assembly LH | Vehicle information registration for the headlight ECU sub-assembly LH | Automatic headlight beam level control system | Refer to REGISTRATION [10/2017 - 10/2020] |
NOTE:
Even if the headlight ECU sub-assembly RH is replaced with a new one, vehicle information registration and initialization are not necessary.
HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.