Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are installed, removed or replaced during the rear combination light assembly removal/installation are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replacement Part or Procedure | Necessary Procedures | Effect/Inoperative Function when Necessary Procedures are not Performed | Link |
|---|---|---|---|
| Rear bumper assembly (Including removal and installation) | Adjust rear LiDAR advanced drive sensor assembly |
|
- |
HINT:
- Use the same procedure for the RH and LH sides.
- The procedure described below is for the LH side.