Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are installed, removed or replaced during the headlight assembly LH removal/installation are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedures | Necessary Procedures | Effect/Inoperative Function when Necessary Procedures are not Performed | Link |
|---|---|---|---|
| Front bumper assembly (Including removal and installation) | Front television camera view adjustment | Panoramic view monitor system | Refer to CALIBRATION [10/2023 - ] |
w/ Front LiDAR Sensor:
|
|
Refer to ADJUSTMENT [11/2021 - ] |
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
- w/o Front LiDAR Sensor:
If the headlight assembly is damaged or deformed due to an accident, contact, etc., and repairs have been made to the area of the body to which the headlight assembly is installed, it is necessary to perform front side radar sensor adjustment.
for Driving Adjustment: Refer to DRIVING ADJUSTMENT [10/2023 - ]
for Target Adjustment (Triangle Target): Refer to TARGET ADJUSTMENT (TRIANGLE TARGET) [10/2023 - ]