Hazard Warning Switch Circuit [10/2020 - 11/2021]: Procedure

1. Using the Techstream, read the Data List.

   Refer to DATA LIST / ACTIVE TEST [10/2020 - 10/2023]

   Body Electrical > Combination Meter > Data List 

   Tester Display	Measurement Item	Normal Condition	Reference Value	Diagnostic Note
   Hazard Flasher Switch	Hazard warning signal switch assembly	OFF or ON	OFF: Hazard warning signal switch assembly off ON: Hazard warning signal switch assembly on	-

   Body Electrical > Combination Meter > Data List 

   Tester Display
   Hazard Flasher Switch

   OK

   Normal condition listed above is displayed.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [10/2020 - 10/2023] 

Result: 

NG 

See step  2

1. Remove the hazard warning signal switch assembly.

   Refer to REMOVAL [10/2017 - ]

2. Inspect the hazard warning signal switch assembly.

   Refer to INSPECTION [10/2017 - ]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE HAZARD WARNING SIGNAL SWITCH ASSEMBLY. Refer to  REMOVAL [10/2017 - ] 

Result: 

OK 

See step  3

1. Disconnect the AA hazard warning signal switch assembly connector.
2. Disconnect the G162*1 or G35*2 combination meter assembly connector.
   1. *1: w/ Advanced Drive
   2. *2: w/o Advanced Drive
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   W/ ADVANCED DRIVE
   
   

   Tester Connection	Condition	Specified Condition
   AA-6 (HAZ) - G162-12 (HZSW)	Always	Below 1 Ω
   AA-3 (E) - Body ground	Always	Below 1 Ω
   AA-6 (HAZ) or G162-12 (HZSW) - Body ground	Always	10 kΩ or higher

   W/O ADVANCED DRIVE
   
   

   Tester Connection	Condition	Specified Condition
   AA-6 (HAZ) - G35-2 (HZSW)	Always	Below 1 Ω
   AA-3 (E) - Body ground	Always	Below 1 Ω
   AA-6 (HAZ) or G35-2 (HZSW) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [10/2020 - 11/2021] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR