LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> LS 500h AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Exterior Lights >> Lighting System (Ext) - Circuit Tests (2 Of 2) >> Lighting System >> Exterior Illumination Circuit [10/2017 - 10/2023] >> Procedure

Exterior Illumination Circuit [10/2017 - 10/2023]: Procedure

  1. PERFORM ACTIVE TEST USING TECHSTREAM 
    1. Perform the Active Test according to the display on the Techstream.

      Refer to DATA LIST / ACTIVE TEST [10/2017 - 09/2018] , or refer to DATA LIST / ACTIVE TEST [09/2018 - 10/2020] , or refer to DATA LIST / ACTIVE TEST [10/2020 - 10/2023]

      Body Electrical > Main Body > Active Test 

      Tester Display Measurement Item Control Range Diagnostic Note
      Exterior Light Outside handle lights OFF or ON -

      Body Electrical > Main Body > Active Test 

      Tester Display
      Exterior Light

      OK

      Outside handle lights illuminate.

      Result

      Result Proceed to
      OK A
      NG (All outside handle lights does not illuminate.) B
      NG (Front outside handle lights does not illuminate.) C
      NG (Rear outside handle lights does not illuminate.) D

    Result: 

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [10/2017 - 09/2018]  , or refer to  PROBLEM SYMPTOMS TABLE [09/2018 - 10/2020]  , or refer to  PROBLEM SYMPTOMS TABLE [10/2020 - 10/2023] 

    Result: 

    See step  3

    Result: 

    See step  5

    Result: 

    See step  2

  2. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU [MULTIPLEX NETWORK BODY ECU] - FRONT DOOR OUTSIDE HANDLE ASSEMBLY LH) 
    1. Disconnect the G17 main body ECU (multiplex network body ECU) connector.
    2. Disconnect the H25 front door outside handle assembly LH connector.
    3. Disconnect the K19 rear door outside handle assembly LH connector.
    4. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      G17-2 (OHIL) - H25-1 (OIL) Always Below 1 Ω
      G17-2 (OHIL) or H25-1 (OIL) - Body ground Always 10 kΩ or higher

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU). Refer to  REMOVAL [10/2017 - 09/2018]  , or refer to  REMOVAL [09/2018 - 10/2020]  , or refer to  REMOVAL [10/2020 - 11/2021]  , or refer to  REMOVAL [11/2021 - 10/2022]  , or refer to  REMOVAL [10/2022 - 10/2023] 

    Result: 

    NG 

    REPAIR OR REPLACE HARNESS OR CONNECTOR 

  3. INSPECT FRONT DOOR OUTSIDE HANDLE ASSEMBLY LH 
    1. Remove the front door outside handle assembly LH.

      Refer to DISASSEMBLY [10/2017 - 09/2018] , or refer to DISASSEMBLY [09/2018 - 10/2020] , or refer to DISASSEMBLY [10/2020 - 11/2021] , or refer to DISASSEMBLY [11/2021 - 10/2022] , or refer to DISASSEMBLY [10/2022 - 10/2023]

    2. Inspect the front door outside handle assembly LH.

      Refer to INSPECTION [10/2017 - ]

      Result

      Proceed to
      OK
      NG

    Result: 

    NG 

    REPLACE FRONT DOOR OUTSIDE HANDLE ASSEMBLY LH. Refer to  DISASSEMBLY [10/2017 - 09/2018]  , or refer to  DISASSEMBLY [09/2018 - 10/2020]  , or refer to  DISASSEMBLY [10/2020 - 11/2021]  , or refer to  DISASSEMBLY [11/2021 - 10/2022]  , or refer to  DISASSEMBLY [10/2022 - 10/2023] 

    Result: 

    OK 

    See step  4

  4. INSPECT FRONT DOOR OUTSIDE HANDLE ASSEMBLY RH 
    1. Remove the front door outside handle assembly RH.

      Refer to DISASSEMBLY [10/2017 - 09/2018] , or refer to DISASSEMBLY [09/2018 - 10/2020] , or refer to DISASSEMBLY [10/2020 - 11/2021] , or refer to DISASSEMBLY [11/2021 - 10/2022] , or refer to DISASSEMBLY [10/2022 - 10/2023]

    2. Inspect the front door outside handle assembly RH.

      Refer to INSPECTION [10/2017 - ]

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    REPAIR OR REPLACE HARNESS OR CONNECTOR 

    Result: 

    NG 

    REPLACE FRONT DOOR OUTSIDE HANDLE ASSEMBLY RH. Refer to  DISASSEMBLY [10/2017 - 09/2018]  , or refer to  DISASSEMBLY [09/2018 - 10/2020]  , or refer to  DISASSEMBLY [10/2020 - 11/2021]  , or refer to  DISASSEMBLY [11/2021 - 10/2022]  , or refer to  DISASSEMBLY [10/2022 - 10/2023] 

  5. INSPECT REAR DOOR OUTSIDE HANDLE ASSEMBLY LH 
    1. Remove the rear door outside handle assembly LH.

      Refer to DISASSEMBLY [10/2017 - 09/2018] , or refer to DISASSEMBLY [09/2018 - 10/2020] , or refer to DISASSEMBLY [10/2020 - 11/2021] , or refer to DISASSEMBLY [11/2021 - 10/2022] , or refer to DISASSEMBLY [10/2022 - 10/2023]

    2. Inspect the rear door outside handle assembly LH.

      Refer to INSPECTION [10/2017 - ]

      Result

      Proceed to
      OK
      NG

    Result: 

    NG 

    REPLACE REAR DOOR OUTSIDE HANDLE ASSEMBLY LH. Refer to  DISASSEMBLY [10/2017 - 09/2018]  , or refer to  DISASSEMBLY [09/2018 - 10/2020]  , or refer to  DISASSEMBLY [10/2020 - 11/2021]  , or refer to  DISASSEMBLY [11/2021 - 10/2022]  , or refer to  DISASSEMBLY [10/2022 - 10/2023] 

    Result: 

    OK 

    See step  6

  6. INSPECT REAR DOOR OUTSIDE HANDLE ASSEMBLY RH 
    1. Remove the rear door outside handle assembly RH.

      Refer to DISASSEMBLY [10/2017 - 09/2018] , or refer to DISASSEMBLY [09/2018 - 10/2020] , or refer to DISASSEMBLY [10/2020 - 11/2021] , or refer to DISASSEMBLY [11/2021 - 10/2022] , or refer to DISASSEMBLY [10/2022 - 10/2023]

    2. Inspect the rear door outside handle assembly RH.

      Refer to INSPECTION [10/2017 - ]

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    REPAIR OR REPLACE HARNESS OR CONNECTOR 

    Result: 

    NG 

    REPLACE REAR DOOR OUTSIDE HANDLE ASSEMBLY RH. Refer to  DISASSEMBLY [10/2017 - 09/2018]  , or refer to  DISASSEMBLY [09/2018 - 10/2020]  , or refer to  DISASSEMBLY [10/2020 - 11/2021]  , or refer to  DISASSEMBLY [11/2021 - 10/2022]  , or refer to  DISASSEMBLY [10/2022 - 10/2023]