Red Indicator Remains On [10/2022 - ]: Procedure

1. Turn the ignition switch to ON and wait for 10 seconds or more.
2. Clear the DTCs.

   Body Electrical > Telematics > Clear DTCs 

3. Check for DTCs and check that no DTCs are output.

   Body Electrical > Telematics > Trouble Codes 

   OK

   No DTCs are output.

   Result

   Proceed to
   OK
   NG

Result: 

NG 

GO TO DIAGNOSTIC TROUBLE CODE CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [10/2022 - 10/2023]  , or refer to  DIAGNOSTIC TROUBLE CODE CHART [10/2023 - ] 

Result: 

OK 

See step  2

1. Check for vehicle control history and note any codes that are output.

   Refer to VEHICLE CONTROL HISTORY (RoB) [10/2022 - 10/2023] , or refer to VEHICLE CONTROL HISTORY (RoB) [10/2023 - ]

   Body Electrical > Telematics > Utility 

   Tester Display
   Vehicle Control History (RoB)

   Result

   Result	Proceed to
   No vehicle control history is output	A
   Any vehicle control history is output	B

Result: 

B 

GO TO VEHICLE CONTROL HISTORY. Refer to  VEHICLE CONTROL HISTORY (RoB) [10/2022 - 10/2023]  , or refer to  VEHICLE CONTROL HISTORY (RoB) [10/2023 - ] 

Result: 

A 

See step  3

1. Replace the DCM (telematics transceiver).

   Refer to REMOVAL [10/2022 - 10/2023] , or refer to REMOVAL [10/2023 - ]

   NOTE:

   • The ignition switch must be off.
   • Do not exchange the DCM (telematics transceiver) with one from another vehicle.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

PERFORM DCM ACTIVATION. Refer to  DCM ACTIVATION [10/2022 - ]