Red Indicator Remains On [10/2020 - 10/2022]: Procedure

1. Turn the power switch off.
2. Connect the Techstream to the DLC3.
3. Turn the power switch on (IG) and wait for 10 seconds or more.
4. Turn the Techstream on.
5. Check for DTCs and check that no DTCs are output.

   Refer to DTC CHECK / CLEAR [10/2020 - 10/2022]

   Body Electrical > Telematics > Trouble Codes 

   OK

   No DTCs are output.

   Result

   Proceed to
   OK
   NG

Result: 

NG 

GO TO DIAGNOSTIC TROUBLE CODE CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [10/2020 - 11/2021]  , or refer to  DIAGNOSTIC TROUBLE CODE CHART [11/2021 - 10/2022] 

Result: 

OK 

See step  2

1. Check for vehicle control history and note any codes that are output.

   Refer to VEHICLE CONTROL HISTORY [10/2020 - 10/2022]

   Body Electrical > Telematics > Utility 

   Tester Display
   Vehicle Control History (RoB)

   Result

   Result	Proceed to
   No vehicle control history is output	A
   Any vehicle control history is output	B

Result: 

B 

GO TO VEHICLE CONTROL HISTORY. Refer to  VEHICLE CONTROL HISTORY [10/2020 - 10/2022] 

Result: 

A 

See step  3

1. Replace the DCM (telematics transceiver).

   Refer to REMOVAL [10/2020 - 11/2021] , or refer to REMOVAL [11/2021 - 10/2022]

   NOTE:

   • The power switch must be off.
   • Do not exchange the DCM (telematics transceiver) with one from another vehicle.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

PERFORM DCM ACTIVATION. Refer to  DCM ACTIVATION [10/2020 - 10/2022]