LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> LS 500h AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Entertainment Systems >> Audio / Video System - Service Information (2 Of 3) >> Amplifier Antenna >> Installation [11/2021 - 10/2023] >> Procedure

Installation [11/2021 - 10/2023]: Procedure

  1. INSTALL NO. 2 AMPLIFIER ANTENNA ASSEMBLY 
    1. Attach the guide.
      GTY795399Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Bolt
      Connector
    2. Install the No. 2 amplifier antenna assembly with the bolt.

      Torque: 8.0 N.m (82 kgf/cm, 71 in.lbf) 

    3. Connect the 2 connectors.
  2. INSTALL NO. 1 AMPLIFIER ANTENNA ASSEMBLY 
    1. Attach the guide.
      GTY777298Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Bolt
      Connector
    2. Install the No. 1 amplifier antenna assembly with the bolt.

      Torque: 8.0 N.m (82 kgf/cm, 71 in.lbf) 

    3. Connect the 2 connectors.
  3. INSTALL INNER ROOF SIDE GARNISH ASSEMBLY RH 

    Refer to PROCEDURE - Step 21

  4. INSTALL INNER ROOF SIDE GARNISH ASSEMBLY LH 

    Refer to PROCEDURE - Step 20

  5. INSTALL PACKAGE TRAY TRIM SIDE COVER RH 

    Refer to PROCEDURE - Step 23

  6. INSTALL PACKAGE TRAY TRIM SIDE COVER LH 

    Refer to PROCEDURE - Step 22

  7. INSTALL PACKAGE TRAY TRIM GARNISH RH 

    Refer to PROCEDURE - Step 25

  8. INSTALL PACKAGE TRAY TRIM GARNISH LH 

    Refer to PROCEDURE - Step 24

  9. INSTALL ROOF SIDE RAIL GARNISH ASSEMBLY RH 

    Refer to PROCEDURE - Step 27

  10. INSTALL ROOF SIDE RAIL GARNISH ASSEMBLY LH 

    Refer to PROCEDURE - Step 26

  11. INSTALL ROOM PARTITION BOARD ASSEMBLY LH (for Power Seat) 

    Refer to PROCEDURE - Step 5

  12. INSTALL ROOM PARTITION BOARD ASSEMBLY RH (for Power Seat) 

    Refer to PROCEDURE - Step 6

  13. INSTALL REAR SEAT SIDE GARNISH RH 

    Refer to PROCEDURE - Step 31

  14. INSTALL REAR SEAT SIDE GARNISH LH 

    Refer to PROCEDURE - Step 30

  15. INSTALL REAR DOOR SCUFF PLATE RH 

    Refer to PROCEDURE - Step 39

  16. INSTALL REAR DOOR SCUFF PLATE LH 

    Refer to PROCEDURE - Step 38

  17. INSTALL REAR SEAT ASSEMBLY 
    1. for Fixed Seat Type:

      Refer to INSTALLATION [11/2021 - 10/2023]

    2. for Power Seat:

      Refer to INSTALLATION [11/2021 - 10/2023]

  18. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL 

    Refer to PROCEDURE - Step 2

  19. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 13

  20. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL 

    Refer to WORK PROCEDURE [11/2021 - 10/2022] , or refer to WORK PROCEDURE [10/2022 - ]

    HINT: 

    When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.

    Refer to AUTOMATIC LEARNING CHART [11/2021 - 10/2023]

  21. INSPECT SRS WARNING LIGHT 
  22. INSPECT REAR SEAT ASSEMBLY (for Power Seat) 

    Refer to OPERATION CHECK [09/2019 - ]

  23. INSPECT SEAT HEATER SYSTEM (w/ Seat Heater System) 

    Refer to OPERATION CHECK [10/2017 - 10/2022] , or refer to OPERATION CHECK [10/2022 - ]

  24. INSPECT CLIMATE CONTROL SEAT SYSTEM 

    Refer to ON-VEHICLE INSPECTION [10/2017 - 10/2022] , or refer to ON-VEHICLE INSPECTION [10/2022 - ]

  25. INSPECT SEAT VIBRATION SYSTEM (w/ Refresh Seat) 

    Refer to OPERATION CHECK [11/2021 - 10/2022] , or refer to OPERATION CHECK [10/2022 - ]

  26. INSPECT SEAT BELT WARNING SYSTEM 

    Refer to ON-VEHICLE INSPECTION [10/2020 - 10/2023]

scientia non olet · About LEMON Manuals