DTC B1575-87: GVIF (from EMV/MM Integrated Device to Multi Display) Missing Message [10/2022 - ]: Procedure

Pre-procedure1

1. Disconnect the G141 multi-display connector.
2. Disconnect the G137 radio receiver assembly connector.

   Procedure1

3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   G137-1 (GVI-) - G141-2 (GV-)	Always	Below 1 Ω
   G137-2 (GVI+) - G141-1 (GV+)	Always	Below 1 Ω
   G137-3 (GVG1) -G141-3 (GVG)	Always	Below 1 Ω
   G137-1 (GVI-) - Body ground	Always	10 kΩ or higher
   G137-2 (GVI+) - Body ground	Always	10 kΩ or higher
   G137-3 (GVG1) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

   Post-procedure1

4. None

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  2

1. Replace the multi-display with a new or known good one.

   Refer to REMOVAL [10/2022 - ]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  3

1. Clear the DTCs.

   Body Electrical > Telematics > Clear DTCs 

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  4

1. Check for DTCs.

   Body Electrical > Telematics > Trouble Codes 

   Result

   Result	Proceed to
   DTCs are not output	A
   DTCs are output	B

Result: 

A 

END (MULTI-DISPLAY IS DEFECTIVE) 

Result: 

B 

REPLACE RADIO RECEIVER ASSEMBLY. Refer to  REMOVAL [10/2022 - ]