DTC P0335-31: Crankshaft Position Sensor "A" No Signal [10/2022 - ]: Procedure

1. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [10/2017 - ]

   Body Electrical > Active Noise Control > Clear DTCs 

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  2

1. Check for DTCs.

   Refer to DTC CHECK / CLEAR [10/2017 - ]

   Body Electrical > Active Noise Control > Trouble Codes 

   OK

   DTC P0335-31 is not output.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [10/2022 - 10/2023]  , or refer to  HOW TO PROCEED WITH TROUBLESHOOTING [10/2023 - ] 

Result: 

NG 

See step  3

1. Disconnect the A94 inverter with converter assembly connector.
2. Disconnect the L7 stereo component equalizer assembly connector.
3. Disconnect the A56 ECM connector.
4. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   L7-3 (NEI) - A56-30 (NEO)	Always	Below 1 Ω
   L7-3 (NEI) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE STEREO COMPONENT EQUALIZER ASSEMBLY. Refer to  REMOVAL [10/2017 - 10/2023]  , or refer to  REMOVAL [10/2023 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR