Caution / Notice / Hint

NOTE:

Make sure to read "Before Starting Driving Adjustment" before proceeding with work.
Refer to BEFORE STARTING DRIVING ADJUSTMENT [10/2023 - ]
Make sure that the alignment is suitable and non-standard tires are not installed.
Make sure to perform the transition to online axis alignment mode with the vehicle stopped.
Transitioning to online axis alignment mode will erase the learning value, so make sure to complete the adjustment.
Turning the power switch off while in online axis alignment mode will cause the system to exit online axis alignment mode, so to continue with the adjustment, it is necessary to transition to online axis alignment mode again.
All of the driving support system functions will be inoperative while the adjustment is in progress.
When driving the vehicle with the Techstream connected, be careful with how the wires are routed.
If the adjustment does not complete within a total cumulative time of 15 minutes when the vehicle is driven with all conditions met, perform the adjustment on another route.
If the adjustment does not complete within a total cumulative time of 30 minutes when the vehicle is driven with all conditions met, perform the adjustment using target recognition.
After adjustment is complete, to start the various systems it is necessary to turn the power switch off and then to ON again.
In situations such as when the online axis alignment terminates abnormally, to perform online axis alignment again, turn the power switch off and then back to ON and enter online axis alignment mode again.
If the front bumper cover has been replaced or body repair has been performed at radio wave transmission area, "driving adjustment" cannot be performed.
If body repairs have been performed at the radio wave transmission area of the front bumper cover, select a target distance of 2500 mm (8.2 ft.) and be sure to perform "Check Reflection Power".
Refer to CHECK REFLECTION POWER [10/2023 - ]