LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> LS 500h AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Monitor System - Service Information (3 Of 3) >> FRONT SIDE RADAR SENSOR (w/ Front LiDAR Sensor) >> Removal [10/2023 - ] >> Caution / Notice / Hint

Caution / Notice / Hint

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the front side radar sensor removal/installation are shown below.

NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedures Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Front bumper assembly (Including removal and installation) Front television camera view adjustment Panoramic view monitor system Refer to CALIBRATION [10/2023 - ]
w/ Advanced Drive: 
  1. Adjust front LiDAR advanced drive sensor assembly
  • Advanced drive system
  • Front LiDAR system
 Refer to ADJUSTMENT [11/2021 - ]
NOTE:
  • Do not drop the front side radar sensor.
  • Do not drop the front side radar sensor. If it is dropped, replace it with a new one.
scientia non olet · About LEMON Manuals