Caution / Notice / Hint

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the television camera assembly removal/installation are shown below.

NECESSARY PROCEDURES AFTER PARTS REMOVED / INSTALLED / REPLACED

Replacement Part or Procedure	Necessary Procedures	Effects / Inoperative when not Performed	Link
Rear television camera assembly (Including removal and installation)	Rear television camera view adjustment Rear television camera view adjustment (for Rear camera detection system)	Parking support alert system Parking support brake system Panoramic view monitor system	Refer to CALIBRATION [10/2017 - 11/2021]
	Parking assist monitor system initialization Rear television camera assembly optical axis (Back camera position setting)	Parking assist monitor system	Refer to CALIBRATION [10/2017 - 10/2020]
Front television camera assembly, front bumper assembly or radiator grille Rear television camera assembly Side television camera assembly LH or outer rear view mirror assembly LH Side television camera assembly RH or outer rear view mirror assembly RH	Television camera view adjustment Rear television camera view adjustment (for Rear camera detection system)	Panoramic view monitor system	Refer to CALIBRATION [10/2017 - 11/2021]
When the luggage compartment door is opened using a mechanical key	Initialize luggage closer motor assembly	The power trunk lid does not operate	Refer to INITIALIZATION [10/2017 - 10/2020]