LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> LS 500h AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Monitor System - Service Information (1 Of 3) >> CLEARANCE WARNING BUZZER (for Rear Side) >> Removal [10/2023 - ] >> Procedure

Removal [10/2023 - ]: Procedure

  1. PRECAUTION 
    WARNING:

    Be sure to read precaution thoroughly before servicing.

    Refer to PRECAUTION [10/2023 - ]

    GTY824211Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    NOTE:

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

    Refer to BEFORE DISCONNECTING BATTERY [10/2023 - ]

  2. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 25

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL 
    1. Disconnect the cable from the negative (-) auxiliary battery terminal.

      Refer to PROCEDURE - Step 4

      WARNING:
      • Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
      • If the airbag deploys for any reason, it may cause a serious accident.
      GTY581108Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY 
    1. for power seat:

      Refer to REMOVAL [10/2023 - ]

    2. for fixed seat type:

      Refer to REMOVAL [10/2023 - ]

  5. REMOVE NO. 2 CLEARANCE WARNING BUZZER 
    GTY815342Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Using a clip remover, detach the clamp and remove the No. 2 clearance warning buzzer.
    2. Disconnect the connector.
scientia non olet · About LEMON Manuals