LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> LS 500h AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Collision/Avoidance >> Monitor System - Service Information (3 Of 3) >> FRONT SIDE RADAR SENSOR (w/ Front LiDAR Sensor) >> Removal [10/2023 - ] >> Procedure

Removal [10/2023 - ]: Procedure

  1. REMOVE FRONT BUMPER ASSEMBLY 

    Refer to REMOVAL [10/2023 - ]

  2. REMOVE FRONT SIDE RADAR SENSOR (for LH Side) 
    1. Disconnect the connector.
      GTY966249Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Connector
      Nut
    2. Remove the 3 nuts and front side radar sensor.

      HINT: 

      Replace nut with a new one.

  3. REMOVE FRONT SIDE RADAR SENSOR (for RH Side) 

    HINT: 

    Use the same procedure described for the LH side.

  4. REMOVE FRONT FENDER REINFORCEMENT SUB-ASSEMBLY TOP LH 

    Refer to PROCEDURE - Step 2

  5. REMOVE FRONT FENDER REINFORCEMENT SUB-ASSEMBLY TOP RH 

    HINT: 

    Use the same procedure described for the LH side.

  6. REMOVE HEADLIGHT ASSEMBLY LH 

    Refer to PROCEDURE - Step 3

  7. REMOVE HEADLIGHT ASSEMBLY RH 

    HINT: 

    Use the same procedure described for the LH side.

  8. REMOVE FRONT SIDE RADAR SENSOR BRACKET LH 
    1. Remove the 3 bolts and front side radar sensor bracket LH.
      GTY966318Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. REMOVE FRONT SIDE RADAR SENSOR BRACKET RH 

    HINT: 

    Use the same procedure described for the LH side.

scientia non olet · About LEMON Manuals