LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> LS 500h AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Collision/Avoidance >> Monitor System - Service Information (3 Of 3) >> BLIND SPOT MONITOR SENSOR (w/o Front LiDAR Sensor) >> Removal [10/2023 - ] >> Caution / Notice / Hint

Caution / Notice / Hint

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during blind spot monitor sensor removal/installation are shown below.

NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedures Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative (-) auxiliary battery terminal Operate the multiplex network master switch assembly (retractable outer mirror switch) to extend and retract the outer rear view mirror assembly Parking support brake system Refer to INITIALIZATION [10/2022 - ]
Initialize rear door sunshade system Rear door sunshade system Refer to INITIALIZATION [10/2017 - ]
Blind spot monitor sensor ECU configuration - Refer to ECU CONFIGURATION [10/2023 - ]
Blind spot monitor beam axis confirmation
  • Parking Support Brake System
  • Blind Spot Monitor System
for Target Adjustment (Triangle Target):
Refer to TARGET ADJUSTMENT (TRIANGLE TARGET) [10/2023 - ] 
for Driving Adjustment:
Refer to DRIVING ADJUSTMENT [10/2023 - ] 
for ECU Data Save/write:
Refer to ECU DATA SAVE/WRITE [10/2023 - ] 
When the luggage compartment door is opened using a mechanical key Initialize luggage closer motor assembly The power trunk lid does not operate Refer to INITIALIZATION [10/2023 - ]

HINT: 

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.