LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> LS 500h AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Collision/Avoidance >> Monitor System - Service Information (1 Of 3) >> Clearance Warning Ecu >> Removal [10/2017 - 10/2020] >> Caution / Notice / Hint

Caution / Notice / Hint

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the clearance warning ECU assembly removal/installation are shown below.

NECESSARY PROCEDURES AFTER PARTS REMOVED / INSTALLED / REPLACED

Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Clearance warning ECU assembly
  • Ultrasonic sensor detection angle
  • Steering angle neutral point
  • Registration of bumper type
  • Ultrasonic sensor detection angle registration
  • Parking support alert system
  • Parking support brake system
 Refer to CALIBRATION [10/2017 - 10/2020]
When the luggage compartment door is opened using a mechanical key Initialize luggage closer motor assembly The power trunk lid does not operate Refer to INITIALIZATION [10/2017 - 10/2020]
scientia non olet · About LEMON Manuals