Installation [10/2020 - ]: Procedure

1. Check that the engine switch is off.
2. Check that the cable is disconnected from the negative (-) battery terminal.
   WARNING:

   • Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
   • If the airbag deploys for any reason, it may cause a serious accident.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

3. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Lock Button
   	Push

   While holding the lower No. 2 instrument panel airbag assembly with one hand, connect the airbag connector and push the lock button to lock it.

   NOTE:

   • When connecting any airbag connector, take care not to damage the airbag wire harness.
   • Make sure the lock button is securely locked.
4. Attach the claw to install the lower No. 2 instrument panel airbag assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Install in this Direction

5. Install the 2 bolts.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

Refer to PROCEDURE - Step 7 [10/2020 - 10/2022] , or refer to PROCEDURE - Step 7 [10/2022 - 10/2023] , or refer to PROCEDURE - Step 7 [10/2023 - ]

Refer to PROCEDURE - Step 38 [10/2020 - 10/2022] , or refer to PROCEDURE - Step 37 [10/2022 - 10/2023] , or refer to PROCEDURE - Step 37 [10/2023 - ]

Refer to PROCEDURE - Step 39 [10/2020 - 10/2022] , or refer to PROCEDURE - Step 38 [10/2022 - 10/2023] , or refer to PROCEDURE - Step 38 [10/2023 - ]

Refer to PROCEDURE - Step 40 [10/2020 - 10/2022] , or refer to PROCEDURE - Step 39 [10/2022 - 10/2023] , or refer to PROCEDURE - Step 39 [10/2023 - ]

Refer to PROCEDURE - Step 43 [10/2020 - 11/2021] , or refer to PROCEDURE - Step 43 [11/2021 - 10/2023] , or refer to PROCEDURE - Step 43 [10/2023 - ]

Refer to PROCEDURE - Step 2 [10/2020 - 10/2023] , or refer to PROCEDURE - Step 2 [10/2023 - ]

Refer to PROCEDURE - Step 11

Refer to WORK PROCEDURE [10/2020 - 10/2022] , or refer to WORK PROCEDURE [10/2022 - 10/2023] , or refer to WORK PROCEDURE [10/2023 - ]

HINT: 

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Refer to AUTOMATIC LEARNING CHART [10/2020 - 10/2023] , or refer to AUTOMATIC LEARNING CHART [10/2023 - ]

Refer to DTC CHECK / CLEAR [12/2017 - 10/2023] , or refer to DTC CHECK / CLEAR [10/2023 - ]

Refer to OPERATION CHECK [12/2017 - 11/2021] , or refer to OPERATION CHECK [11/2021 - 10/2023] , or refer to OPERATION CHECK [10/2023 - ]