LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> LS 500 Base, RWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brake System (Front) - Service Information >> FRONT BRAKE (except 6-Pot Caliper) >> Removal [10/2023 - ] >> Procedure

Removal [10/2023 - ]: Procedure

  1. REMOVE FRONT WHEEL 

    Refer to REMOVAL [10/2023 - ]

  2. DRAIN BRAKE FLUID 
    NOTE:

    If brake fluid leaks onto any painted surface, immediately wash it off.

  3. REMOVE FRONT DISC BRAKE PAD 

    Refer to PROCEDURE - Step 3

  4. REMOVE FRONT DISC BRAKE ANTI-SQUEAL SHIM 

    Refer to PROCEDURE - Step 4

  5. DISCONNECT FRONT FLEXIBLE HOSE 
    1. Remove the union bolt and gasket, and disconnect the front flexible hose from the disc brake cylinder assembly LH.
      GTY832424Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE DISC BRAKE CYLINDER ASSEMBLY LH 
    1. Remove the 2 bolts and disc brake cylinder assembly LH from the steering knuckle.
      GTY798707Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. REMOVE FRONT DISC LH 
    1. Put matchmarks on the front disc LH and the front axle hub sub-assembly LH.
      GTY1237546Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Matchmark

      HINT: 

      Not required when replacing the front disc LH.

    2. Using a 5 mm hexagon socket, remove the bolt.
    3. Remove the front disc LH.
      NOTE:

      Check that the bolt has been fully removed.

scientia non olet · About LEMON Manuals