LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> LS 500 Base, RWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Meter / Gauge / Display - Service Information >> Trip Switch >> Inspection [12/2017 - ] >> Procedure

Inspection [12/2017 - ]: Procedure

  1. INSPECT TRIP SWITCH 
    1. Check the resistance.
      GTY800333Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 ODO TRIP Switch
      *a Component without harness connected
      (Trip Switch)
      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection Switch Condition Specified Condition
        G8-4 (A/B) - G8-7 (E) ODO TRIP Switch pressed Below 1 Ω
        ODO TRIP switch not pressed 10 kΩ or higher

        If the result is not as specified, replace the trip switch.

    2. Check illumination.
      GTY800330Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Trip Switch)
      1. Apply battery voltage to the trip switch and check that it illuminates.

        OK

        Tester Connection Specified Condition
        G8-3 (ILL+) - Battery positive (+)
        G8-8 (ILL-) - Battery negative (-)        		 Illuminates

        If the result is not as specified, replace the trip switch.

scientia non olet · About LEMON Manuals