LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> LS 500 Base, AWD >> Repair and Diagnosis >> Engine Mechanical >> Starter >> Engine Starting System - Service Information >> Starter >> Removal [09/2018 - 10/2020] >> Procedure

Removal [09/2018 - 10/2020]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Refer to PRECAUTION [12/2017 - 10/2020]

  2. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 24

  3. REMOVE LUGGAGE COMPARTMENT FLOOR MAT 

    Refer to PROCEDURE - Step 23

  4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [09/2018 - 10/2020]

  5. REMOVE ENGINE ASSEMBLY WITH TRANSMISSION 

    Refer to REMOVAL [09/2018 - 10/2020]

  6. REMOVE CONVERTER ASSEMBLY RH 

    Refer to PROCEDURE - Step 8

  7. DISCONNECT FRONT FRAME ASSEMBLY (for AWD) 

    Refer to PROCEDURE - Step 141

  8. REMOVE FRONT ENGINE MOUNTING INSULATOR (for AWD) 

    Refer to PROCEDURE - Step 142

  9. REMOVE FRONT NO. 1 ENGINE MOUNTING BRACKET RH (for AWD) 

    Refer to PROCEDURE - Step 143

  10. DISCONNECT NO. 2 ENGINE WIRE 
    1. Remove the 2 bolts and disconnect the No. 2 engine wire.
      GTY795510Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  11. REMOVE FLYWHEEL HOUSING SIDE STAY 
    1. Remove the 2 bolts and flywheel housing side stay.
      GTY795509Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  12. REMOVE STARTER COVER 
    1. Remove the bolt, nut and starter cover.
      GTY834097Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Bolt
      Nut
  13. REMOVE STARTER ASSEMBLY 
    1. for 2WD:
      1. Remove the bolt and disconnect the oil cooler tube.
        GTY795511Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Detach the claw and open the terminal cover.
      GTY831728Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the nut and disconnect the No. 2 engine wire from the terminal B.
      GTY795499Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Disconnect the connector and detach the clamp.
      GTY811168Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Connector
      Bolt
    5. Remove the 2 bolts and starter assembly.
scientia non olet · About LEMON Manuals