Removal [03/2017 - ]: Procedure

Refer to PROCEDURE - Step 8 [03/2017 - 06/2019] , or refer to PROCEDURE - Step 8 [06/2019 - 04/2020] , or refer to PROCEDURE - Step 8 [04/2020 - 05/2023] , or refer to DISASSEMBLY [05/2023 - ]

Refer to PROCEDURE - Step 10 [03/2017 - 06/2019] , or refer to PROCEDURE - Step 10 [06/2019 - 04/2020] , or refer to PROCEDURE - Step 10 [04/2020 - 05/2023] , or refer to DISASSEMBLY [05/2023 - ]

1. Disconnect the connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Remove the 7 screws of the backside of the front door trim board sub-assembly RH.
3. Remove the screw of the face of the front door trim board sub-assembly RH.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

4. Remove the power window regulator switch assembly with the No. 1 switch base as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   	Remove in this Direction (1)
   	Remove in this Direction (2)

5. Remove the 2 screws.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

6. Detach the guide and remove the No. 2 switch base from the No. 1 switch base.
7. Using a thin-bladed screwdriver, detach the claw and remove the power window regulator switch assembly from the No. 2 switch base.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   HINT: 

   Tape the thin-bladed screwdriver tip before use.