Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front roof side rail weatherstrip removal/installation are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedures | Effect/Inoperative Function when Necessary Procedures are not Performed | Link |
|---|---|---|---|
| Front seat assembly RH (Only for removal and installation) | Zero point calibration (Occupant classification system) |
|
Refer to INITIALIZATION [03/2017 - ] |
HINT:
- When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
- Learning completes when vehicle is driven
Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. Refer to INITIALIZATION [05/2023 - ] Pre-collision system Variable gear ratio steering system Refer to INITIALIZATION [03/2017 - ] - Learning completes when vehicle is operated normally
Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link Air conditioning system After the engine switch is turned to ON, the servo motor standard position is recognized. -
- Learning completes when vehicle is driven
- Use the same procedure for the RH side and LH side.
- The procedure listed below is for the LH side.