LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> LC 500 >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Navigation System - Diagnostic Codes (Coupe) (2 Of 2) & Symptom Tests (1 Of 2) >> Navigation System >> Illumination for Panel Switch does not Come on with Tail Switch ON [04/2020 - 05/2023] >> Procedure

Illumination for Panel Switch does not Come on with Tail Switch ON [04/2020 - 05/2023]: Procedure

  1. CHECK VEHICLE SIGNAL (OPERATION CHECK) 
    1. Enter the "Vehicle Signal Check Mode" screen. Refer to Check Vehicle Signal in Operation Check.
      GTY325562Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Refer to OPERATION CHECK [04/2020 - 05/2023]

    2. Check that the display for "TAIL" changes between ON and OFF according to the light control switch operation.

      OK

      Light Control Switch Display
      Tail or head ON
      AUTO OFF

      HINT: 

      • This display is updated once per second. As a result, it is normal for the display to lag behind the actual switch operation.
      • Make sure to move the vehicle to a bright area before performing an operation check with the light control switch in the AUTO position.

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    REPLACE RADIO RECEIVER ASSEMBLY. Refer to  REMOVAL [03/2017 - 05/2023] 

    Result: 

    NG 

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [04/2020 - 10/2022]  , or refer to  PROBLEM SYMPTOMS TABLE [10/2022 - 05/2023]