Installation [04/2013 - 08/2015]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2017 Lexus IS 350, 2017 Lexus IS 300, 2016 Lexus IS 350, 2016 Lexus IS 300, and 2015 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FUEL PRESSURE PULSATION DAMPER ASSEMBLY

Apply a light coat of engine oil to the threads and gasket seating surface of the fuel pressure pulsation damper assembly.

Install 2 new gaskets, the fuel tube sub-assembly and fuel pressure pulsation damper assembly to the fuel pump assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*1	Gasket
*2	Fuel Pressure Pulsation Damper Assembly
*3	Fuel Tube Sub-assembly

Using SST, tighten the fuel pressure pulsation damper assembly to the fuel pump assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Length of SST 52 mm (2.05 in.)
*b	Length of Torque Wrench 180 mm (7.09 in.)

SST: 09612-24014
1. 09617-24011

Without SST [Torque (N*m (kgf*cm, ft.*lbf))]

Torque: 40 N*m (408 kgf*cm, 30 ft.*lbf)

With SST [Reading of Torque wrench (N*m (kgf*cm, ft.*lbf))]

Torque: 31 N*m (316 kgf*cm, 23 ft.*lbf)

HINT:

This torque value is effective when SST is parallel to the torque wrench.
The "with SST" torque value is effective when using SST with a fulcrum length of 52 mm (2.05 in.).
The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 180 mm (7.09 in.).
If using a torque wrench with a different length, or connecting the torque wrench and SST at an angle, refer to the alternate torque values.
Refer to PRECAUTION [04/2013 - 08/2015]

INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE
Refer to PROCEDURE - Step 3
CONNECT NO. 2 VENTILATION HOSE
Refer to PROCEDURE - Step 4
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [04/2013 - 06/2014] , or refer to INITIALIZATION [06/2014 - 08/2015]
INSPECT FOR FUEL LEAK
Refer to PROCEDURE - Step 1
INSTALL V-BANK COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 105