LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> GX 460 Base >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Air Conditioning System (Service Information) >> Compressor >> Removal [08/2015 - 08/2020] >> Procedure

Removal [08/2015 - 08/2020]: Procedure

  1. REMOVE FAN AND GENERATOR V BELT 
    1. Remove the fan and generator V belt (Refer to REMOVAL [08/2015 - ] ).
  2. REMOVE LOWER FRONT BUMPER COVER 

    Refer to PROCEDURE - Step 7

  3. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 8

  4. REMOVE TRANSMISSION UNDER COVER 

    Refer to PROCEDURE - Step 9

  5. REMOVE REAR ENGINE UNDER COVER ASSEMBLY 

    Refer to PROCEDURE - Step 10

  6. REMOVE FRONT FENDER APRON SEAL LH 

    Refer to PROCEDURE - Step 11

  7. DRAIN ENGINE COOLANT 

    Refer to PROCEDURE - Step 5

  8. REMOVE RADIATOR RESERVOIR ASSEMBLY 

    Refer to PROCEDURE - Step 9

  9. REMOVE NO. 1 RADIATOR HOSE 

    Refer to PROCEDURE - Step 10

  10. REMOVE FAN SHROUD 

    Refer to PROCEDURE - Step 11

  11. DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY 
    1. Remove the 2 bolts and disconnect the discharge hose from the cooler compressor.
      GTY287496Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the O-ring from the discharge hose.
      NOTE:

      Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.

  12. DISCONNECT SUCTION HOSE SUB-ASSEMBLY 
    1. Remove the 2 bolts and disconnect the suction hose from the cooler compressor.
      GTY279835Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the O-ring from the suction hose.
      NOTE:

      Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.

  13. REMOVE COOLER COMPRESSOR ASSEMBLY 
    1. Disconnect the connector.
      GTY279834Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 3 bolts, nut and cooler compressor.
    3. Remove the stud bolt.
scientia non olet · About LEMON Manuals