LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> GX 460 Base >> Repair and Diagnosis >> Drivelines & Axles >> Axle Shafts >> Drive Shaft / Propeller Shaft (Service Information) >> Front Propeller Shaft Assembly >> Installation [08/2015 - ] >> Procedure

Installation [08/2015 - ]: Procedure

  1. INSTALL FRONT PROPELLER SHAFT ASSEMBLY 
    1. Align the matchmarks on the yoke and differential flange.
    2. Install the propeller shaft assembly with the 4 bolts, 4 washers and 4 nuts.

      Torque: 88 N*m (899 kgf*cm, 65 ft.*lbf) 

    3. Align the matchmarks on the yoke and transfer flange.
    4. Install the propeller shaft assembly with the 4 washers and 4 nuts.

      Torque: 88 N*m (899 kgf*cm, 65 ft.*lbf) 

  2. INSTALL PROPELLER SHAFT HEAT INSULATOR WITH BRACKET 
    1. Install the propeller shaft heat insulator with bracket with the 2 bolts.

      Torque: 16 N*m (160 kgf*cm, 12 ft.*lbf) 

  3. INSTALL FRONT EXHAUST PIPE 
    1. Install the front exhaust pipe (Refer to INSTALLATION [08/2015 - ] ).
scientia non olet · About LEMON Manuals