Removal [08/2020 - ]: Procedure

Refer to PROCEDURE - Step 1

Refer to REMOVAL [08/2020 - ]

1. Remove the cap from the rear stabilizer link assembly LH.
2. Loosen the nut (A) of the rear stabilizer link assembly LH.

   HINT: 

   If the ball joint turns together with the nut, use a 6 mm hexagon socket wrench to hold the stud bolt.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

3. Loosen the bolt of the rear stabilizer link assembly LH.
   NOTE:

   Because the nut (B) has its own stopper, do not turn the nut (B). Loosen the bolt with the nut (B) secured.

4. Using a jack and a wooden block, support the rear No. 2 suspension arm assembly.
   NOTE:

   • When jacking up the rear No. 2 suspension arm assembly, be sure to jack it up slowly.
   • Make sure to perform this operation with the vehicle kept as low as possible.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Wooden Block
   *b	Jack

5. Remove the bolt, 2 nuts and rear stabilizer link assembly LH.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT: 

Perform the same procedure as for the LH side.

1. Remove the 4 bolts, rear stabilizer bar, 2 rear No. 1 stabilizer bar brackets, 2 rear stabilizer bushings and 2 rear lower stabilizer brackets from the rear suspension member sub-assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the 2 rear lower stabilizer brackets from the rear stabilizer bushing.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the 2 rear No. 1 stabilizer bar brackets from the 2 rear stabilizer bushings.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the 2 rear stabilizer bushings from the rear stabilizer bar.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002