Data List / Active Test [06/2018 - ]

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2024 Lexus ES 350, 2024 Lexus ES 250, 2023 Lexus ES 350, 2023 Lexus ES 250, and 2022 Lexus ES 350. However, it is still accessible from the selected car via links, so may be relevant.

DATA LIST

HINT:

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

Connect the Techstream to the DLC3.
Turn the engine switch on (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / Main Body or Smart Access / Data List.

Read the Data List according to the display on the Techstream.

Body Electrical > Main Body > Data List

Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
Communication D-Door Motor	Connection status between power window regulator motor assembly (driver door) and main body ECU (multiplex network body ECU)	OK or STOP	OK: Connected STOP: Not Connected	DTC is output if an error occurs in LIN communication.
Communication P-Door Motor	Connection status between power window regulator motor assembly (front passenger door) and main body ECU (multiplex network body ECU)	OK or STOP	OK: Connected STOP: Not Connected	DTC is output if an error occurs in LIN communication.
Communication RR-Door Motor	Connection status between power window regulator motor assembly (rear RH door) and main body ECU (multiplex network body ECU)	OK or STOP	OK: Connected STOP: Not Connected	DTC is output if an error occurs in LIN communication.
Communication RL-Door Motor	Connection status between power window regulator motor assembly (rear LH door) and main body ECU (multiplex network body ECU)	OK or STOP	OK: Connected STOP: Not Connected	DTC is output if an error occurs in LIN communication.
Communication Slide Roof	Connection status between main body ECU (multiplex network body ECU) and sliding roof ECU (sliding roof drive gear sub-assembly)1 or sliding roof ECU (sliding roof drive gear assembly)2	OK or STOP	OK: Connected STOP: Not Connected	DTC is output if an error occurs in LIN communication.
Communication Master SW	Connection status between multiplex network master switch assembly and main body ECU (multiplex network body ECU)	OK or STOP	OK: Connected STOP: Not Connected	DTC is output if an error occurs in LIN communication.
Communication Double Locking	Connection status between double lock door control relay assembly and main body ECU (multiplex network body ECU)*3	OK or STOP	OK: Connected STOP: Not Connected	Not applicable
The Number of DTC	Number of DTCs	0 to 255	Number of stored DTCs	-

*1: w/ Sliding Roof System
*2: w/ Panoramic Moon Roof System
*3: Although the item is displayed on the Techstream, it is not applicable to this vehicle.

Body Electrical > Smart Access > Data List

Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
# Codes	Number of DTCs	0 to 255	Number of stored DTCs	-