DTC U0100: Lost Communication with ECM / PCM "A"; DTC U0125: Lost Communication with Yaw Rate Sensor Module; DTC U0126: Lost Communication with Steering Angle Sensor Module; DTC U0129: Lost Communication with Brake System Control Module; DTC U0142: Lost Communication with Body Control Module "B"; DTC U0293: Lost Communication With Hybrid Vehicle Control System [06/2018 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2024 Lexus ES 350, 2024 Lexus ES 250, 2023 Lexus ES 350, 2023 Lexus ES 250, and 2022 Lexus ES 350. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK DTC
- Turn the engine switch off.
- Turn the engine switch on (IG).
- Recheck for DTCs and check if the same DTC is output again.
Body Electrical > Blind Spot Monitor Master > Trouble Codes
Body Electrical > Blind Spot Monitor Slave > Trouble Codes
Result
Result Proceed to Blind Spot Monitor Master DTCs including DTC U0232 are output. A Blind Spot Monitor Master DTCs other than DTC U0232 are output. B No DTCs are output C HINT:
- If CAN communication system DTCs are stored, they may also be stored for other systems.
- If the CAN communication system has been inspected and repaired, the DTCs will not be output when rechecking for DTCs.
- If these DTCs are output frequently, duplicate the conditions that cause the problem symptoms and perform troubleshooting again, even though the DTC was not output when rechecking for DTCs.
Result:
A
GO TO DTC U0232. Refer to DTC U0232: Lost Communication with Blind Spot Monitor Slave Module [06/2018 - 09/2022] , or refer to DTC U0232: Lost Communication with Blind Spot Monitor Slave Module [09/2022 - ]
Result:
B
GO TO CAN COMMUNICATION SYSTEM. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [06/2018 - ]
Result:
C
USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [06/2018 - ]